Home / Styli

Styli

Styli for CMMs, Equator comparators and machine-tool probes: selection, matching, fault diagnosis and replacement. Thread systems M2, M3 and M4.

M2/M3/M4Part numbersBall materialCalibration
6articles
5sub-columns
15years in the field

Styli are the only part of a measuring system that touches the workpiece, and they decide much of the result. This library covers the selection, matching, fault diagnosis and replacement of styli used on coordinate measuring machines (CMM), Renishaw Equator comparators and machine-tool probes.

Three thread systems dominate the shop floor: M2 on CMM touch probes such as TP20 and TP200, M3 on many CMM and Equator configurations, and M4 on machine-tool probes and tool setters. Pick the thread first, then the ball diameter, then the stem material and length — in that order, because each choice constrains the next.

  • Thread and interface — which probe head the stylus must fit, and whether an adaptor is acceptable.
  • Ball diameter — small enough to reach the feature, large enough to keep contact stress and filtering errors under control.
  • Stem material — ceramic, tungsten carbide, carbon fibre or stainless steel, traded against weight, stiffness and cost.
  • Calibration — every stylus change invalidates the stored tip position; re-qualify before the next measurement.

Practical articles below are grouped by CMM, machine tool and Equator applications, plus the basics of specification and care.

Featured

Editor's picks